12 May 2015
This app quickly calculates the number of cartridges of Anchoring Adhesive necessary to complete your specific installation.
03 Jan 2014
The VBS-M is approved for application in the brick center as well in the mortar joints of the brickwork. It is especially suitable for restoration in which the insulation system is post applied to the brickwork.
03 Jan 2014
The advantages of this innovation have direct and practical effects on the craftsmen's work: as much as 40 percent less time from setting the drill hole to setting the anchor
The TOGE TSM-A is the first genuine high-perfomance fixing element for asphalt.
One drill hole, one to three strokes of the ATA2004 resin compound deliver a fixing offering unprecedented options. 40 kN, 50 kN or even 80 kN exposed to repeat shock loads have so far been difficult to realise in concrete, not these failure loads can also be accomplished in road asphalt. Once installed, the TSM-A provides a collar plate as support surface for base plates and an M10 resp. M16 internal thread for fixtures. As the collar plate is propped against the building member to be fixed, the anchoring is free of prestressed loads. Any hot-galvanised screw or bolt can be used, tensile strength depending on the requirements of the fixing.
Not suitable for permanent tensile load exposure!
How to install:
Set drill hole with correspondent diameter and depth
Clean out drill hole
Inject resin compund ATA 2004
Turn in bold flush with the asphalt surface
Before turning in the bolt, slightly grease the interior thread of the TSM-A to protect it from moisture